V-Twin 40-0488 - Replica Chrome TT Bobber Short Oil Tank

Replica chrome TT Bobber oil tank is 1-5/16" shorter in order to accommodate a raised position for chain alignment.
NOTE: Purpose of tank is to raise the transmission and clutch pak for TT racing or hillclimbing for greater ground clearance. raise transmission mount plate with 1-5/16" spacers and mount as stock. Battery compartment is shorter in this tank so a smaller battery is required. Chain guard will be in a raised position so modifications must be made to the front mount tab. Most TT bikes did not use a chain guard in the early racing era. Use (2) 3"x3/8" SAE bolts and (2) 2-1/2"x3/8" SAE bolts to mount transmission plate. Oil tank fromt mount must be removed and rewelded in place 1.25" upward. Use a spacer 5 required on the 5th mount bolt (1) 2"x2/8" NC. The raising of the trans

Measurements:

Height Front: 5-7/8"
Height Rear: 5"
Depth: 8"
Depth of Battery: 5"
Width: 10"
Battery Width: 4-3/4"

Tech Note:

Suggested to use #8115-1 #8114-1 or #9504-1 timing plugs.
Suggested to use with #37-1018 Black Spacer Set 3/8" X 1" X 1-5/16"
Suggested to use with #53-0520 Black H-3 6V Battery
Suggested to use with #53-0549 Mini 12V 6 Amp AGM Battery
Suggested to use with #53-0571 12V Sealed Battery